Place the screws in through the holes and tighten them using a screwdriver. Install the new lock on the location where your old one used to be located. This would prevent you from buying the wrong one. Provide these measurements to the hardware store where you will buy the lock. After that, get the measurements of the lock and the door. To purchase the right lock for your sliding door, you need to remove the screws of the handle and dismantle the lock. Step 2: Remove the lock’s handle by unscrewing the screws and get the measurements of the lock If the lock does not still work after you cleaned it, then you have to buy a new lock to replace the old one. To do this, pour a lubricant into the lock and rub the pencil on your key before putting the key into the lock. Step 1: Check if the lock needs cleaning or repairingīefore you start dislodging the lock, check first if it needs to be replaced or cleaned only. You can use a ruler to measure the width of the door, the space between the holes for the screws, and other dimensions of the lock. Just rub the pencil on your key to coat it with graphite. You will need a pencil to lubricate your lock. Recommend article: how to properly lubricate a door lock? Pencil The only disadvantage of using an oil is that dust could easily get stuck if the lock is not cleaned frequently. If you don’t have any available WD-40, you can also use any other penetrating lubricants that you prefer.Īs an alternative, you can also use oil to clean the lock if you don’t have any other lubricants. It is also safe on steel and aluminum materials. You can use a WD-40 to clear the dust on the lock mechanism. Often, cleaning a lock will get it to work again. LubricantĪ lubricant is needed to clean the lock. The thinner the screwdriver is, the longer its reach is. Like Philips screwdriver, it is available in various sizes. If the screw head is slotted, a flat head screwdriver is the best tool to use. If too small, it would be difficult to tighten the screws. If it is too huge, it can damage the screws. Phillips screwdrivers have different sizes, so you need one that will fit the screws perfectly. If it has a cross-shaped screw head, you will need a Phillips screwdriver. The screwdriver you need will depend on the type of screws your lock has. For easy installation, make sure that the lock includes mounting screws so you won’t need to look for them. It must also have a mortise lock and thumb latch.Ĭhoose a lock that could be installed on the kind of door you have, since some work only for a specific kind of door. For convenience, look for a lock that has an interior handle and exterior pull with a key cylinder. In choosing a replacement lock, make sure that it would fit your sliding door by getting the measurements of the door and your old lock. You don’t have to worry since these items can be found inside your home or it can be purchased at the nearest hardware store.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |